Iron-on Instructions
Pour les instructions en français, voir ci-dessous
***Note - We changed our iron-on adhesive in June 2025. If you received a patch from Planet Patch before this date, refer to your iron-on instructions found with your order.
Ready to add your new patch to your bag, jacket or cap?
These instructions will get you there.
1. Clean and iron the item that will receive your patch (no fabric softener)
Don't iron your patch to materials that will easily melt or have been treated with a water-resistant coating.
2. Set iron to medium setting
3. Turn off the steam function
4. Place the patch face-up on the item
5. Cover your patch with piece of thin cotton fabric or cloth
6. Hold the hot iron down firmly over your patch for 8-10 seconds.
7. Allow patch to cool for 3 minutes
8. If possible, turn the item over and hold the iron firmly on the back of the patch for 5-7 seconds. This will draw the glue into the item fabric.
Full adhesion takes up to 48 hours, so try to avoid the temptation to test the edges of the patch. This will break the adhesion, and cause failure.
Some materials won't take the iron-on adhesive well. We have tried to find the best adhesive available, but sometimes it just doesn't work. If your patch doesn't stick, or if the item is to be washed or used frequently (like a backpack or ball cap), sewing is highly recommended.
A sewn-on patch will last through much more wear and tear over time
Prêt à ajouter votre nouveau patch à votre sac, veste ou casquette ?
Ces instructions vous y mèneront.
1. Nettoyez et repassez l'article qui recevra votre écusson (sans adoucissant). Ne repassez pas votre écusson sur des tissus qui fondent facilement ou qui ont été traités avec un revêtement imperméable.
2. Réglez le fer à repasser sur une température moyenne.
3. Désactivez la fonction vapeur.
4. Placez l'écusson face vers le haut sur l'article.
5. Recouvrez l'écusson d'un morceau de coton fin ou d'un chiffon.
6. Maintenez fermement le fer chaud sur l'écusson pendant 8 à 10 secondes.
7. Laissez l'écusson refroidir pendant 3 minutes.
8. Si possible, retournez l'article et maintenez fermement le fer au dos de l'écusson pendant 5 à 7 secondes. Cela permettra à la colle de pénétrer dans le tissu.
Une adhérence complète prend jusqu'à 48 heures ; évitez donc de tester les bords de l'écusson. Cela romprait l'adhérence et entraînerait une défaillance.
Certains matériaux n'acceptent pas bien l'adhésif thermocollant. Nous avons essayé de trouver le meilleur adhésif disponible, mais il arrive que cela ne fonctionne pas. Si votre patch n'adhère pas, ou si l'article doit être lavé ou utilisé fréquemment (comme un sac à dos ou une casquette), il est fortement recommandé de le coudre.
Un patch cousu résistera beaucoup plus longtemps à l'usure.